1 · Upload paste layer
↑
Drop or choose your paste layer
SVG, Gerber, .gtp, .gbp and more
Start with your PCB paste layer. Processing stays in this browser.
2 · Board edge cuts
Optional
⌑
Add board outline
Gerber or SVG edge cuts
Add Edge_Cuts.gbr, .gm1 or .gko to size the stencil to your board and enable a locating lip.
Size is set by the edge cuts outline
Tiny pads are included by default. Resin printers are recommended below 0.1 mm.
Paste Pads
Click and drag in the preview to toggle pads.
Board Lip
mm
Match this to your board thickness.
mm
Tune this for your printer and material; increase it if the fit is too tight.
Panelization
Adds room only around the outside of a solid panel; boards and their lips do not move.
Load a paste layer SVG or Gerber to begin