GitHub - tom-ilan/cycloidal_gearbox: 3D Printed Cycloidal Gearbox

This is my cycloidal gearbox I built, and the python script I created to generate it! A cycloidal gearbox is a type of gearbox that allows you to turn rotational speed into torque.

Design Process

Version 1

This gearbox was a handcranked gearbox specifically meant to test the validity of the python cycloidal generator. It had a gear ratio of 1:9.

Version 2

This design was a micro cycloidal gearbox with a ratio of 1:9, meant to only take up the same footprint as a NEMA 17. Due to the tight tolerances needed for a small cycloidal drive and the lack of precision offered by 3D printing, this design did not work.

Version 3

This gearbox was the first working version to run on a NEMA 17. It has a larger footprint compared to Version 2 allowing greater tolerances and a fully functional design.

🛠️ The Python Script

This python script was based on the SolidWorks article Building a Cycloidal Drive with SOLIDWORKS. The two main parametric equations I used were:

$$x = R \cos(t) - E \cos(N t) - r \cos(t + \psi), \quad y = R \sin(t) - E \sin(N t) - r \sin(t + \psi)$$ $$\psi = \text{atan2}\left(\sin((1 - N) t), \frac{R}{E \cdot N} - \cos((1 - N) t)\right)$$ Reduction ratio: $1 : (N - 1)$ (rotor rotates opposite to input shaft).

Installation & Execution

1. Clone the repo
2. Open Fusion 360 and launch Scripts and Add-Ins (Shift + S).
3. Under the Scripts tab, click + (Plus) to add a script.
4. Select the cycloidal_generator folder and click Run.

Key Parameters

• Pins ($N$) & Pitch Radius ($R$): Sets outer stationary housing geometry (Rotor has $N-1$ lobes).
• Eccentricity ($E$): Input shaft offset distance. (Constraint: $R > E \cdot N$).
• Outer Pin Radius ($r$): Roller pin radius. (Constraint: validated against undercut limit $r_{\text{max}}$).
• Precision / Profile Offset: Angular step size and tolerance offset ($+$ for 3D print clearance).
• Output Pins & Bolt Radius: Defines concentric output pins and rotor clearance holes ($r_{\text{pin}} + E$).

🚀 Version 3 — Detailed Overview & Stats

Key Specifications & Performance Stats

Further room for growth

1. The housing pins can be replaced with MR128 bearings allowing for less friction and higher efficiency in the gearbox.

2. The output pins can be replaced with M2 screws with metal coverings to increase rigidity, maximum torque output, and the efficiency of the gearbox.